Control Change Message (Only Page A) - Access Virus Rack User Manual

s The default setting is
HiPage=SysEx.Page C contains Multi
parameters and Global parameters.
These parameters are sent and
received only by SysEx Parameter
Change.
In the following, all bytes are shown in
hexadecimal representation.
í
Control Change mes-
sage (only Page A)
Bc Status byte,
c=MIDI channel
nn Parameter Number 0..127
(see parameter list Page A)
vv Parameter Value 0..127
see parameter list Page A)
. The Control Change messages are
defined as Performance Controller (e.g.
Modulation Wheel or Hold Pedal) or
Sound Parameters (e.g. Cutoff or Patch
Volume). The Performance Controllers
are not stored with a Single-Sound. If
more than one Multi Part is set to the
same MIDI channel, all Parts on this MIDI
channel receive the same Performance
Controllers. The Sound Parameters are
stored with a Single Sound. If more than
one Multi Part is set to the same MIDI
channel, the Sound Parameter is receiced
only by the Multi Part with the lowest
part number.
Example: B0,21,40 Set oscillator balance
(21 hex = 33 dec) on MIDI channel 1 to
the middle position (40 hex =64 dec).
ACCESS VIRUS RACK 205
System Exclusive Data