Kodak HEALTH SCIENCES MINILOADER 2 Plus Low Voltage Stand-Alone Installation Instructions Manual page 9

INSTALLATION INSTRUCTIONS
17. Remove the TOP and BOTTOM COVERS from the M35-M DRIER ASSEMBLY and retain. Remove
the EXIT PLATE from the DRIER ASSEMBLY and keep one of the longer SCREWS (8/32 UNC x
5/8"). Discard the EXIT PLATE and the other SCREWS. Fit the new EXIT PLATE supplied using the five
new SCREWS and the one retained SCREW. See FIGURE 7.
Figure 7
New exit plate
18. Complete all the PLUMBING and WIRING to the PROCESSOR. See FIGURE 8 for the purpose of
the HOLES in the REAR PANEL.
Figure 8
Stand-by/Run switch
Processor power cable
January 1995
Retained screw here
Exhaust
Water inlet
Page II-9
New screws (5)
Replenisher inlets
W F
D
Drain outlets
II 3420
© Kodak Ltd.