Unpacking And Installation Instructions For Stand-Alone Version - Kodak HEALTH SCIENCES MINILOADER 2 Plus Low Voltage Stand-Alone Installation Instructions Manual

II 3420

UNPACKING AND INSTALLATION INSTRUCTIONS FOR STAND-ALONE VERSION.

1. Remove the BANDING from the PACKING CASE then lift the CARTON off the MINILOADER
PALETTE.
2. Remove the MAGAZINES from the top of the MINILOADER and unpack them.
The case should contain:-
PART No. QUANT
xxxxxxxx
30023169
30023168
30026197
30026239
30026240
30025845
30025846
30025847
30025849
3. Remove the LID and lift the MINILOADER onto a suitable STAND or BENCH. See figure 18 for
details of the holes required in the STAND or BENCH to secure the MINILOADER. See APPENDIX
"A" for drawings of suitable STANDS.
!! CAUTION TWO PEOPLE ARE REQUIRED TO LIFT THE MINILOADER !!
Figure 18
660 mm
© Kodak Ltd.
DESCRIPTION
1 MINILOADER 2 PLUS STAND-ALONE VERSION
1 SUPPLY MAGAZINE 18x24 MAMMO
1 SUPPLY MAGAZINE 24x30 MAMMO
1 SUPPLY MAGAZINE 8x10 INCH VIDEO
1 RECEIVING MAGAZINE 18x24 MAMMO
1 RECEIVING MAGAZINE 24x30 MAMMO / MIXED SIZES
4 LARGE FLAT WASHERS, INTERNAL DIAMETER 8 MM
4 SET SCREW, HEXAGON HEAD, M8 x 40 MM
4 SET SCREW, HEXAGON HEAD, M8 x 60 MM
1 CAN OF TOUCH-UP PAINT
Drill 4 HOLES 10 mm
diameter in the
STAND or BENCH.
Feed
end.
INSTALLATION INSTRUCTIONS
690 mm centres
Receiving
end
770 mm
Page II-16
580 mm
centres
January 1995