Kodak HEALTH SCIENCES MINILOADER 2 Plus Low Voltage Stand-Alone Installation Instructions Manual page 28

II 3420
APPENDIX "A"
The STAND shown here is suitable for use with a model 480RA MINILOADER interfaced to a M6B / 460RA
/480RA PROCESSOR. With adaption it could be used for a STAND-ALONE MINILOADER. If used for a
STAND-ALONE MINILOADER, it would be necessary to drill four HOLES as shown in figure 18 (page II-
16) in the TOP to bolt the MINILOADER to the STAND.
FRONT VIEW
190
190
190
© Kodak Ltd.
740
4 TWIN WHEEL HEIGHT
ADJUSTABLE CASTORS
WITH BRAKED PLATE
FIXING
Page II-28
INSTALLATION INSTRUCTIONS
760
835
OVERALL
HEIGHT
65
THESE CASTORS
MUST BE RECESSED
TO ALLOW THE
STAND TO WHEEL UP
TO THE PROCESSOR
January 1995