Unpacking And Installation Instructions For 480Ra Version - Kodak HEALTH SCIENCES MINILOADER 2 Plus Low Voltage Stand-Alone Installation Instructions Manual

INSTALLATION INSTRUCTIONS

UNPACKING AND INSTALLATION INSTRUCTIONS FOR 480RA VERSION.

1. Remove the BANDING from the PACKING CASE then lift the CARTON off the MINILOADER
PALETTE.
2. Remove the MAGAZINES from the top of the MINILOADER and unpack them.
The case should contain:-
PART No. QUANT
xxxxxxxx
30023169
30023168
30026197
30023197
30026262
30015540
30015564
30015612
30025845
30025846
30025848
30025849
3. Fit the four LEVELLING SCREWS (30025846) to the tapped HOLES in the BASE of the
MINILOADER.
4. Remove the LID and lift the MINILOADER onto its STAND. Drawings of suitable STANDS are
shown in APPENDIX "A".
!! CAUTION TWO PEOPLE ARE REQUIRED TO LIFT THE MINILOADER !!
5. If the STAND is metal, an earth connection must be made between the STAND and the
MINILOADER.. IMPORTANT - ENSURE THE PAINT IS REMOVED WHERE THE EARTH
CONNECTIONS ARE MADE.
7. Remove the left hand SIDE PANEL from the MINILOADER.
January 1995
DESCRIPTION
1 MINILOADER 2 PLUS VERSION 480RA
1 SUPPLY MAGAZINE 18x24 MAMMO
1 SUPPLY MAGAZINE 24x30 MAMMO
1 SUPPLY MAGAZINE 8x10 INCH VIDEO
1 SERIAL UNLOADING MAGAZINE 18x24 MAMMO
1 SERIAL UNLOADING MAGAZINE 24x30 MAMMO
2 SCREW, M4 x 30 (USED TO FASTEN MINILOADER TO PROCESSOR)
2 NUT, M4 (USED TO FASTEN MINILOADER TO PROCESSOR)
2 NUT, THIN, M4 (USED TO FASTEN MINILOADER TO PROCESSOR)
4 LARGE DIAMETER WASHER M4 (USED TO FASTEN MINI TO PROC)
4 SCREW, HEXAGON HEAD, M8 x 40 (MINI LEVELLING FEET)
4 WASHER, FLAT, M8
1 CAN OF TOUCH-UP PAINT
Page II-13
II 3420
© Kodak Ltd.