Table of Contents
Advertisement
Application parameters
Application parameters are parameter-specific for the selected application.
Display image
P_1901
P_1902
System, 1=He, 2=Co, 3=ChOv, 4=HC, 5=R
Min 1
0=ext.temp, 1 or 2 room units
Min 0
P_1903
Frost guard temp
Min 5
P_1904
Economy mode available?
Min 0
P_1907
Night cool, Set point
Min 10
P_1908
Actuator Cool, 1=NC, 2=0-10V, 3=NO, 4=CCO
Min 1
P_1909
Window, 0=NP, 1=NC, 2=NO, 3=CODry
Min 0
P_1910
Occupancy, 0=NP, 1=NC, 2=NO
Min 0
P_1911
RU back to auto state
Min 0
P_1912
Room unit´s min set point
Min 0
20210201
Description
Indicates how the climate
4
system should operate for
heating and cooling.
1 = Heating only, 2 = Cooling
Max 5
only, 3 = Change-over function
4 = Heating/Cooling, 5 =
Heating with radiator
Indicates whether one or
1
two room units are used. If 2
units are used they should be
connected with a cable.
Max 2
0 = ext.temp, 1 = 1 unit
2 = 2 units
Indicates at which temperature
10 °C
the frost protection should
switch in.
Max 12
Indicates whether the Economy
1
mode is available.
0 = No
1 = Yes
Max 1
Indicates the temperature
18 °C
setpoint applicable to the Night
cool function.
Max 32
Cooling actuator type.
1
1=Normally closed
2= 0-10V
3=Normally open
Max 4
4=CCO
Window contact type.
0
0=Not used
1=Normally closed
2=Normally open
Max 3
3=Dry switch for changing cool/
heat in change-over system
Indicates whether a presence
0
detector is installed and if so
how it is installed.
0 = No contact installed
Max 2
1 = Normally closed
2 = Normally open
Indicates how long after the
480 min
most recent manual room
temperature adjustment that
the controller should return to
Max 1200
the AUTO mode.
0 = Not used
Indicates which lowest
16 °C
temperature is possible to
adjust manually on the room
unit in the MAN operating
Max 50
mode.
Swegon reserves the right to make design changes.
CONDUCTOR W4
57
Advertisement
Table of Contents
