Table of Contents
Advertisement
CONDUCTOR W4
Connect units room unit (RU) to controller (RE)
<Exit
Figure 11. Image for selecting RF pair-up and the RF pair-up image.
The units must be connected together in order to control the controller by
means of a hand-held micro terminal. This is done by entering the RF (radio
frequency) ID of the controller, which is specified on the identification plate
of the controller.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Return to the Settings menu by pressing the ◄ Left key.
11. Return to the Service menu by pressing the ◄ Left key.
46
Swegon reserves the right to make design changes..
Room unit no.
RF pair-up
RF Quality
Select>
Go to the Service menu.
Highlight Settings.
Press OK or on the ► Right key.
Mark Connect units.
Press OK or on the ► Right key.
Enter the first digit in the RF ID number by pressing the ▲ UP key or
▼ DOWN key.
Highlight the next digit position by pressing the ► Right key.
Enter the remaining four digits in the RF ID number.
Press OK to confirm the RF ID number and connect the room unit to
the controller.
If the connection is successful, the text: Connected will be shown.
RF pair-up
0
0 0 0 0
<Exit
20210201
>
Advertisement
Table of Contents
