Table of Contents
Advertisement
CONDUCTOR W4
Booting
As soon as the controller and the room unit have been energized, the
system boots up and the main view is shown in the display of the room unit.
The controller is in the AUTO operating mode when the system has finished
booting.
Figure 6. Main view in the display of the room unit.
3.
Selection of Language
On delivery, the room unit has factory-preset English language settings.
4.
Check the factory settings
5.
To connect units
In order for the controller to be able to properly communicate with the
room unit, they must be connected up to one another.
6.
34
Swegon reserves the right to make design changes..
Check that the main view is shown in the display.
Change to desired language in accordance with instructions in the
section: Room unit menus.
Make sure that the current application setting is in agreement with
units connected to the controller. Check in accordance with instructions
in the section: Room unit menus.
N.B.!
If the room unit is operated via the controller, you need not
connect it.
Connect the controller and the room unit to one another in accordance
with the instructions in section: Room unit menus. The ID number of
the controller should be given as address when connecting up.
20210201
Advertisement
Table of Contents
