Table of Contents
Advertisement
CONDUCTOR W4
Set the cut-in temperature for cooling and heating
<Exit
Figure 8. Image for selecting Regulator adjustment settings and image for setting the cut-in
1.
2.
3.
4.
5.
6.
7.
8.
9.
View current flows in the air ducts
<Exit
Figure 9. Image for selecting RE settings and image for setting the existing airflows.
1.
2.
3.
4.
5.
44
Swegon reserves the right to make design changes..
Service Menu
Regulator adjust
Settings
Select>
temperature for cooling and heating.
Go to the Service menu.
Highlight the Regulator adjustment settings.
Press OK or on the ►Right key.
Press the ► Right key three times to show the image for setting the
cut-in temperature for cooling and heating.
Highlight the line of the value (cooling or heating) you want to change
by pressing the ▲ UP or ▼ DOWN key.
Press OK to highlight and to be able to change the cut-in temperature.
Change the cut-in temperature by pressing the ▲ UP or ▼ DOWN key.
Press OK to confirm the change.
Press the ◄ Left key four times to return to the Service menu.
Service Menu
Regulator adjust
Settings
Select>
Go to the Service menu.
Highlight the Regulator adjustment settings.
Press OK or on the ►Right key.
Press the ► Right key four times to show the image for current flows in
the supply air ducts and in the extract air duct.
Return to the Service menu by pressing the ►Right key.
Temp C
20
Temp H
20
<Prev.
OK select
Next>
Flow SA1 l/s
30
Flow SA2 l/s
60
Flow EA l/s
90
<Prev.
Exit>
20210201
Advertisement
Table of Contents
