Huawei FusionServer G5500 User Manual page 91

FusionServer G5500 Server
User Guide
Figure 5-8 Initial configuration process
Table 5-7
Table 5-7 Configuration process
Step
Check the G560.
Configure the iBMC.
Log in to the remote virtual
console.
Configure RAID.
Configure the basic input/
output system (BIOS).
Issue 02 (2017-12-15)
Start
Check the G560.
Configure the iBMC.
L og in to the remote virtual
console.
C onfigure RAID.
Configure the BIOS.
Install an OS.
End
describes the initial configuration process.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Action
l Check the version information of the G560 and ensure
that the version information meets site requirements.
l Check for alarms about the G560.
l Change the default password for the iBMC.
l Configure the iBMC IP address for the G560.
Log in to the iBMC WebUI, and then log in to the G560
on the Remote Control page.
The G560 supports two RAID controller cards:
l LSI SAS3008: supports RAID 0 and 1.
l LSI SAS3108: supports RAID 0, 1, 5, 6, 10, 50, and
60.
Configure the G560 BIOS settings, including the boot
mode, BIOS password, and Preboot Execution
Environment (PXE) options for network interface cards
(NICs).
5 Configuring the G5500
83