Huawei FusionServer G5500 User Manual page 43

FusionServer G5500 Server
User Guide
l
Procedure
Power on the compute node using the iBMC WebUI.
1
2
Issue 02 (2017-12-15)
NOTE
The default value of Power Strategy is Turn on, which indicates that the compute node
automatically powers on after power is supplied to PSUs. To change the value of Power Strategy,
log in to the iBMC WebUI and choose Power > Power Control.
If PSUs are powered on and the compute node is in the standby state, power on the
compute node as follows:
NOTE
When the power indicator is steady yellow, the compute node is in the standby state.
– Press the power button on the front panel to power on the compute node. For details
about the power button position, see
– Power on the compute node using the iBMC WebUI. For details, see
compute node using the iBMC
– Power on the compute node using the iBMC command-line interface (CLI) in
remote management mode.
Log in to the iBMC CLI of the G560. For details, see
n
iBMC CLI.
Log in to the iBMC CLI of the G530 V2. For details, see
n
the iBMC CLI.
Run the ipmcset -d powerstate -v 1 command on the iBMC CLI to power on the
compute node remotely.
Log in to the iBMC WebUI of the compute node to be powered on.
To log in to the iBMC WebUI of the G560, see
To log in to the iBMC WebUI of the G530 V2, see
WebUI.
Choose Power > Power Control.
The Power Control page is displayed, as shown in
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2.3 Front Panel Indicators and
WebUI.
5.4.1 Logging In to the iBMC
5.5.1 Logging In to the iBMC
Figure 3-2.
3 Basic Operations
Buttons.
Power on the
5.4.4 Logging In to the
5.5.4 Logging In to
WebUI.
35