Huawei FusionServer G5500 User Manual page 131

FusionServer G5500 Server
User Guide
Figure 6-1 Locations of SAS/SATA hard disks and NVMe SSDs
To ensure optimal access performance, install NVMe SSDs in sequence from slots 2, 5, 3, 6, 4, to 7.
Step 2 Take a spare hard disk out of its ESD bag.
Step 3 Raise the ejector lever completely and insert the hard disk into the slot. See (1) in
Figure 6-2 Installing a hard disk
Step 4 Lower the ejector lever until it is latched. See (2) in
Step 5 Configure the hard disk based on the actual situation. The following is only for reference:
l
l
Issue 02 (2017-12-15)
NOTE
If the original hard disk is not in the RAID array, the new hard disk becomes idle. You
are advised to set the new hard disk as a global or dedicated hot spare disk. The
procedure ends.
If the original RAID array (for example, RAID 0) does not support redundancy,
reconfigure RAID. The procedure ends.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 Optional Part Installation
Figure 6-2.
Figure 6-2.
123