Intec ARGUS Manual page 49

Incoming Call
An incoming call can be taken at any time even when a test (e.g. a BERT) is in process
(see page 67). The ARGUS will signal an incoming call with an audible tone and a
message on the display. The function Accept call (see the ARGUS main Manual) can be
configured so that, on a P-P access, the ARGUS will only signal incoming calls that are
placed to its own call number. This function can only be used when the own call number
has been entered into the speed-dialing memory (see the ARGUS main Manual) and the
incoming call has a call number.
Reject call
Disconnect
Charge information in NT mode:
In NT mode, the ARGUS will – for incoming calls – send advice of charges in accordance
with DSS1 as units and as currency (in euros).
ARGUS PRI

Display:
-
-
-
-

The ARGUS will display the complete
destination number (DDI), if the Alerting
mode is set to manual (see the ARGUS
main Manual).

To take the call.



Depending on the access, additional
information will be displayed (in this
example, TON and NP).


<Volume>
<TM>

or
The ARGUS displays the cause of the
disconnect (see page 50).

4 Operation on a PRI Access
B-channel used and service
The caller's number (from:)
Destination number (to:)
Other information depending on the
access, e.g. TON and NP
Setting the volume
Starts the Test Manager 
(see page 66)
49