Operation On A Pri Access; Configuring The Pri Interface And Access Mode Settings - Intec ARGUS Manual

4 Operation on a PRI Access

4 Operation on a PRI Access
4.1

Configuring the PRI Interface and Access Mode Settings

Use the included connection cable to connect the ARGUS "BRI/PRI/EI" jack to the access
to be tested and then switch the ARGUS on. The PRI settings are made in chapter 2
Configuring accesses page 7. In this example the PRI TE mode was selected.
ARGUS State display
Main menu
16
Start the B-channel test
<Start>
Open the "PRI Setting"
<Config>
menu.
Open L1 state
Switch the pin assignment
<X>
(will not be displayed until
the Level key is pressed)
The menus, which are available for the
type of access under test, are listed in the
main menu.
The ARGUS will open the
marked menu (in this example,
Single tests).
Select a menu. The selected
menu will be marked blue in the
display.
To return to the previous menu
(in the example, the State
display).
ARGUS PRI