Opening The Charging Column - Mennekes Basic 3,7 Operating And Installation Manual

Fig. 6: Unpacking
Unpack the charging column:
f Loosen the strapping of cardboard packaging.
f Lift the cardboard packaging.
f Remove the key set (1) from the head-side hard foam
base.
f Remove the hard foam packaging.
f Remove the charging column.
f Place the charging column upright on the transport
pallet or on a soft surface.

5.5 Opening the Charging Column

T
WARNING
Risk of injury due to tipping over of the device
Even if slightly touched, an unsecured device can tip over
and squeeze people. In addition, the device can be dama-
ged.
f Only place the device on a level surface.
f Protect the device from tipping over.
f Mount the device quickly on a foundation.
Fig. 7: Opening the cover
f Disconnect device from voltage.
f Open the lock (2) on the back of the charging column
f Fold the cover plate (1) upwards.
1
Fig. 8: Releasing the turning lever
f Fold the lock cover (1) to the side.
f Insert the key (2) into the profile cylinder und release
1
2
with the double bit key.
2
1
the turning lever (3).
A second profile cylinder may be used in the
turning lever if necessary. This would allow the
opening of the charging column with a further key
set. The factory fitted dummy cylinder must be
removed first.
3
11
EN