HYOSUNG NH-1800CE Operator's Manual page 132

NH-1800CE 5. Operator Function
If DHCP value is ENABLE, ATM uses DYNAMIC IP to connect to host. Otherwise, ATM uses STATIC
IP. If you change DHCP value from ENABLE to DISABLE, you should set up STATIC IP again use IP
ADDRESS, SUBNET MASK, GATEWAY and DNS buttons.
Note: In case of selecting "IN SERVICE" on OP MAIN, if the value of DHCP (or IP, SUBNET MASK,
GATEWAY, DNS) is different from the original value of DHCP (or IP, SUBNET MASK, GATEWAY,
DNS) when entering in OP mode, exit OP and execute reboot.
5.8.3.1 IP ADDRESS
The IP ADDRESS function is used to edit the ip address.
Please input the ip address in the field and select OK button. If it succeeded, "OPERATION
SUCCESSFUL!" displays.
It is able to input up to 15 units such as XXX.XXX.XXX.XXX
5- 94