HYOSUNG NH-1800CE Operator's Manual page 226

NH-1800CE
Physical Installation
To install NH 1800CE ATM, perform the following steps.
1) Place the " Anchor bolts locate sheet " at the place where the machine is to be installed. (refer to
Fig. 6.8)
Place the system on a flat surface. Be careful when opening the top or bottom of the machine so
it can be off balance
2) Place the Anchor nuts into the ground according to the anchor bolts locate sheet.
(4 places)
3) Place NH 1800CE ATM on top of the sheet.
4) Open the Security cover with the key provided.
5) Using the supplied combination (factory preset at 50-25-50) open the Security Door.
This combination should be changed as soon as possible. Refer to Chapter 5 for
instructions on changing the lock combination.
6) After the anchor nuts are in place according to the anchor holes on the bottom of
NH 1800CE ATM, tighten the anchor bolts tightly. (refer to 6.8)
6- 46
6. Appendix