HYOSUNG NH-1800CE Operator's Manual page 228

NH-1800CE
Hardware Installation
1) Verify the power voltage (110/220V) to be used and set the appropriate voltage on
the power supply.
2) Verify that the telephone line to be used for the ATM is in proper working order. Hyosung
recommends the use of shielded phone line in locations with close proximity to other appliances.
(For Dial-up)
3) Open the security door and remove any shipping materials and note any warning or installation
instructions.
4) Remove the screw, which is set to hold the Cash Dispensing Unit platform in place.
5) Remove the cash cassette from the box, fill the cassette with the appropriate amount of notes, and
place it in the Cash Dispensing Unit carefully. Place the appropriate denomination label on the
front of the cassette.
6) Before closing the vault, thoroughly test the combination lock by locking and unlocking the lock
several times. It is much easier to diagnose potential lock problems before shutting the door
7) Open the top of the ATM. Place the receipt paper in the Receipt Printer. The paper prints only on
one side (shiny side) always check the roll when you install paper.
Place the roll so that the coated side (shiny side) will be facing up.
8) Connect the Power cable and telephone cable to the appropriate outlets on the wall.
(verify once again if the power voltage is 110V or 220V)
9) Turn the power on and verify if all systems are operational. If any part of the system is not
operational then an error code will be displayed. Verify with the Error Code and follow the
appropriate steps. If the error is not corrected please contact your local distributor. Set all the
system parameters. For more detailed information refer to Chapter 5 and Chapter 6.
6- 48
6. Appendix