Set Point (Spc Or Spf); Saving Restart Period (Sr); Saving Set Point (Ssp) - Elstat ems55advanced Manual

description Enables the input from the motion sensor.
considerations Must be disabled if a motion sensor is not fitted.
range 00 (disabled) or 01 (enabled)
global default 01 (enabled)
10.37

set point (SPC or SPF)

The table below details the set point (S PC or S PF) parameter.
display
Defines the compressor cut-out temperature during the ready mode. The set point (S P) temperature is
the lowest measured temperature under normal operating conditions.
description
The set point is displayed as S PC (set point Celsius) or S PF (set point Fahrenheit) depending on whether
the ems controller is set to use Celsius or Fahrenheit.
considerations Must be above the freeze-up protection (dtt) temperature.
range -9.9 to 9.9°C (14 to 50°F)
3.0°C (37°F)
global default
ems75sz: -3.0°C (27°F)
10.38

saving restart period (Sr)

The table below details the saving restart period (S r) parameter.
display
Defines the maximum time allocated to reach the set point (S P) temperature from the saving mode tem-
description
perature.
Set and verified by OEMs through the test protocol to ensure that product temperatures are within specification
l
when outlets open.
considerations
Must be set in multiples of 30 minutes.
l
range 0 to 240 minutes (in multiples of 30 minutes)
global default 120 minutes
10.39

saving set point (SSP)

The table below details the saving set point (S S P) parameter.
ems55advanced and ems55Radvanced / General Use
80 of 84