How To Perform A Half Reset (Hr) - Elstat ems55advanced Manual

Press the up button to start, and test, the analogue inputs described in the following table:
9.
button display
or
10. Press the defrost and set buttons simultaneously to test the motion sensor.
The display changes to
11. Press the defrost button and then place your hand about 300mm in front of the motion sensor.
Move your hand from left to right and ensure the following:
The display count increments for each detected movement.
l
The motion LED flashes for each detected movement.
l
12. Press the defrost and set buttons simultaneously to end the test routine.
7.7

how to perform a half reset (Hr)

Perform a half reset to clear the self-learning matrix if the ems controller has been unable to detect activity correctly, for
example, the view of the motion sensor was blocked, or if the cooler has been moved to a new location.
Perform a half reset as follows:
Press and hold the set button until PAS is displayed.
1.
2. Enter the button sequence of the menu entry password.
PS
3. Ensure that
is displayed.
Press down to scroll down to the Hr menu.
4.
ems55advanced and ems55Radvanced / General Use
42 of 84
test
appliance
sensor
temperature
door switch
condenser
sensor
temperature
evaporator
sensor
temperature
PI r
.
check
displayed temperature is correct
door is open (dO) or closed
(C L O)
displayed temperature is correct