Celsius Or Fahrenheit (Cf); Refrigeration System Failure (Ct); Display Stability (D2) - Elstat ems55advanced Manual

display
Calibrates or adds an offset to temperatures measured by the evaporator sensor. The offset helps the
description
positioning of the evaporator sensor.
Applied to all temperatures measured on the evaporator sensor.
considerations Used only with sub zero and OFC firmware.
Not available on GDC firmware.
range -9.9 to 9.9ºC (-18 to 18ºF)
global default 0.0ºC (0ºF)
10.10

Celsius or Fahrenheit (CF)

The table below details the Celsius or Fahrenheit parameter (C F).
display
description Option to set the ems controller to Celsius (°C) or Fahrenheit (°F).
A global reset sets ems controllers using Fahrenheit (°F) to Celsius
l
(°C).
considerations
Applies to all temperature settings and values.
l
range 00 (°C) or 01 (°F)
global default 00 (°C)
10.11

refrigeration system failure (Ct)

The table below details the refrigeration system failure (C t) parameter.
display
Defines the maximum continuous runtime of the compressor without reaching the set point (S P) tem-
perature.
description
If the set point (S P) temperature is not reached within this time, the ems controller switches off the com-
pressor and activates the refrigeration system (rS F) alarm.
considerations None
range 00 to 100 hours
global default 72 hours
10.12

display stability (d2)

The table below details the display stability (d2) parameter.
ems55advanced and ems55Radvanced / General Use
70 of 84