How To Run The Test Routine (Tst) - Elstat ems55advanced Manual

7.6

how to run the test routine (tst)

The test routine tests the following:
all load relays
l
analogue inputs (temperature sensors and door switch)
l
motion sensor.
l
Run the test routine as follows:
ems55advanced and ems55Radvanced / General Use
40 of 84
See "calibration 2 (CA2)" on
page 69
See "saving set point (SSP)" on
page 80
See "saving differential (Sd)" on
page 79
See "freeze-up protection (dtt)
" on page 74
See "condenser high tem-
perature (Ht)" on page 76
See "defrost activation tem-
perature (ddt)" on page 71
See "defrost termination tem-
perature (dtd)" on page 73
See "compressor rest time (rt)
" on page 79
See "delay to saving (dS)" on
page 73
See "lights delay (Ld)" on page
77
See "saving restart period (Sr)"
on page 80
See "refrigeration system fail-
ure (Ct)" on page 70
See "Maximum defrost on
demand time (dtO)" on page
74
See "fan cycle on (FCO)" on
page 75
See "fan cycle off (FCF)" on
page 75
See "display stability (d2)" on
page 70
See "high voltage (HI)" on
page 76
See "low voltage (LO)" on
page 77
See "buzzer enable (b0)" on
page 68
See "activity frequency (AF)"
on page 67
See "motion sensor enable
(Sn)" on page 79
See "saving temperature dis-
able (PEr)" on page 78
See "learning period (LP)" on
page 78
See "display (dIS)" on page 72