Table of Contents
Advertisement
CRC-C
CRC-D
Press and hold the button ^ on the USB docking cradle and then check that the message below appears after a short
7.
delay and click OK.
If the transfer was unsuccessful, check all connections and settings and repeat the procedure.
If the error persists, this indicates a malfunction of the equipment.
8. Remove the parameter programming tool from the USB docking cradle.
9.10
how to view the download counter
When programming a large quantity of parameter programming tools (dongles), a display counter can be viewed.
To view the download counter, click Tools > Download counter.
Note:The download counter window must be displayed to count.
9.11
how to view version of the parameter programming tool (dongle)
View the version of a parameter programming tool (dongle) as follows:
1. Insert the parameter programming tool (dongle) into the USB docking cradle.
Click Tools > Get dongle version to display the dialog below.
2.
Checksum displayed on an ems55advanced with firmware version E52 F07.
Displayed after manually scrolling through the parameter list, following down-
load of the parameter settings with the parameter programming tool (dongle).
Checksum displayed on all other ems controllers following download of the
parameter settings with the parameter programming tool (dongle).
ems55advanced and ems55Radvanced / General Use
63 of 84
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the ems55advanced and is the answer not in the manual?
Questions and answers
O meu aparelho está desregulado.....como colocar os números q vieram de fábrica nele