Symbols Used In This Manual; Serial Number Location - Honda EU65is Service Manual

cap.02 EU65is 6500is (Eu).qxd 07.12.17 4:25 PM ページ2-3

4. SYMBOLS USED IN THIS MANUAL

As you read this manual, you may find the following symbols with the instructions.
A special tool is required to perform the procedure.
Apply grease.
Apply oil.
x ( ) Indicates the diameter, length, and quantity of metric flange bolts used.
P. 1-1 Indicates the reference page.
CONNECTOR NUMBER AND TERMINAL ARRANGEMENT
Indicates the connector No. connecting one wire harness to another.
Indicates the connector No. connected to a part.
C11 Indicates the connector No.
GND3 Indicates the ground terminal No.
T12 Indicates the terminal No.
• See P. 2-51 thru. 2-64 CABLE/HARNESS ROUTING for the
connector locations and terminal arrangement of the
connectors.
• The terminal No. on inspection shows the terminal
arrangement by viewing the connector from the terminal
side. Note that the double frame connector indicates a male
terminal connector, while the single frame indicates a female
terminal connector.

5. SERIAL NUMBER LOCATION

The engine serial number is stamped on the right cylinder block, and the frame serial number is shown at the frame.
Refer to these serial numbers when ordering parts or making technical inquiries.
ENGINE SERIAL NUMBER
2-3
LOCK
Female terminal connector
viewed from the terminal side
LOCKS
Male terminal connector
viewed from the terminal
side
FRAME SERIAL NUMBER
LOCK