RGBlink GX2L User Manual page 39

Note:After setting the sending card, it is necessary to click "Save to the sending card", otherwise the previous setting
will be lost after power off and restarting.
GX2L/GX4L
3. Click "Receiving Card" to enter the interface as shown in
the left figure.
4. Click "Smart Settings" to set receiving card.
5. Chip selection:select the chip for the corresponding
module.
Data Type:It is generally to choose parallel driver for
common modules by default (If you would like to
customize some modules needed to select serial data,
please contact with our company.
Module Type:If width of single module is 16,then choose
"Regular light board".If not,then choose"Profiled lamp
board(with taps)".
the actual number of:the width of single module
Number of data rows:the height of single module
Number of data line:It can be viewed according to the
number of RBG groups defined by the module
interface.
Line decoding mode:as shown in the left figure
Number of data sets:Conventional and Serial can be
selected.
Cascade direction:Left to right/Right to left/Top to
bottom/Bottom to top
User Manual 39