Optional equipment
Brake system
The machine can be equipped with a pneu-
matic or hydraulic brake system. The machine is
equipped with a parking brake for safe parking.
DANGER
Uncontrolled rolling of the machine can cause
severe injuries by crushing or rolling over.
Park the machine only on level ground with
¾
sufficient load bearing capacity.
Secure the machine with wheel chocks
¾
against rolling before releasing the brake.
Pneumatic brake
The pneumatic brake is a dual-line single-circuit
braking system with pressure regulator.
2
V1
V1
Z1
Z1
Rot
Rot
Rot
LB
LB
LB
Gelb
Gelb
Gelb
ZB
ZB
ZB
Z2
Z2
1
3
1 Coupling head Brake - yellow
2 Coupling head Provision - red
3 Brake valve unit
4 Pressure converter
5 Air reservoir
6 Drain valve
7 Brake cylinder
Connection
1. First connect the coupling head "Brake"
(yellow).
2. Then connect the coupling head "Provision"
(red).
3. Release the parking brake.
98
Z5
Z5
4
A3
A3
A1
A1
A2
A2
Z3
Z3
7
5
Z4
Z4
A4
A4
6
V2
V2
Unhitch
1. Apply the parking brake.
2. First disconnect the coupling head "Provi-
sion" (red).
3. Then disconnect the coupling head "Brake"
(yellow).
Maintenance
Drain the air reservoir every day during op-
¾
eration.
Air vessel with drain valve
Clean the pipe filter in the coupling heads
¾
whenever required, but at least once every
year.
To ensure the function of the valves, anti-
¾
freeze should be added to the compressed air.
Follow the operating instructions of the tractor!
The coupling heads should be closed with
¾
lids to protect against damage caused by
moisture.
Operate the brake several times after wash-
¾
ing the machine to cause the brake drum to
become hot and any water in the drum to
evaporate. This will prevent damage to the
brake during extended idle times.