Figure 2.15 Attaching The Power Cable - Fujitsu ETERNUS LT40 S2 Installing, Starting Up And Maintaining

Chapter 2 Installing the Tape Library
2.6 Connecting
2
Attach one end of the signal cable
• to the SAS connector of a SAS tape drive.
• to the FC connector of a FC tape drive.
3
Attach the other end of the signal cable
• in a SAS configuration to the SAS HBA or a SAS expander.
• in a FC configuration to the FC HBA, an FC hub, an FC device with two I/O ports or an FC switch.
4
Attach the power cable to the power connector on the back panel of the Library (see
2.15).
5
Plug the power cable into the nearest properly grounded power outlet.

Figure 2.15 Attaching the power cable

6
Turn on the library using the power button. Check the LCD screen to make sure the library is
receiving power. If it is not, check the power connections and your power source. During the
Power-On-Self-Test (POST), all four LEDs are illuminated briefly, followed by a flashing Ready
LED. When the initialization sequence is complete, the Home screen will be displayed.
7
Plug in the host server or workstation and all attached devices.
8
Turn on any other devices you turned off earlier.
9
Turn on the server.
FUJITSU Storage ETERNUS LT40 S2/LT60 S2 LTO Library Installing, Starting Up and Maintaining
To disconnect all power from the library, remove the power cord from the
CAUTION
outlet. The power button only puts the power on stand-by.
Copyright 2018 FUJITSU LIMITED
34
Figure
End of procedure
P3AM-5392-07ENZ0