Chapter 4 Troubleshooting
4.3 Removing Stuck Tapes From Slots
4.3
Removing Stuck Tapes From Slots
Procedure
1
Unlock the magazine and remove it from the library.
•
Use the OCP, see section
•
Use the RMU, see section
2
The finger holes on the back side of the magazines (see
the cartridges out of the slot. Remove and insert the cartridge mechanically. Repeat the
process ten times.
Figure 4.1 Removing stuck tapes from slot
3
During this process the burr will be removing.
4
Insert cartridge in the magazine.
5
Put the magazine back to the tape Library. Pull lightly on the magazine to check that it is
locked.
FUJITSU Storage ETERNUS LT40 S2/LT60 S2 LTO Library Installing, Starting Up and Maintaining
"5.7 Removing and Replacing a Magazine Using the OCP" (page
"5.8 Removing and Replacing a Magazine Using the RMU" (page
76
Copyright 2018 FUJITSU LIMITED
Figure
4.1) allow the user to pull
End of procedure
P3AM-5392-07ENZ0
92).
93).