Chapter 5 Servicing the Tape Library
5.6 Replacing a Redundant Power Supply
■
Replacing the power supply
Procedure
1
Unpack the new power supply from its package.
2
Slowly insert the new power supply into the bay, and align the connectors on the library
while supporting the power supply assembly.
3
Tighten the captive thumbscrews until the power supply is secure.
4
Replace the power cord cable.
5
Switch on power to the library (power button on the front panel).
5.6
Replacing a Redundant Power Supply
The second power supply can be installed without powering down the library.
Figure 5.8 Replacing a redundant power supply
Procedure
1
Loosen the three screws on the library see
2
Unpack the redundant power supply from its package.
3
Slowly insert the new power supply into the bay (see
4
and align the connectors on the library while supporting the power supply assembly.
FUJITSU Storage ETERNUS LT40 S2/LT60 S2 LTO Library Installing, Starting Up and Maintaining
Figure
5.8, step 1).
91
Copyright 2018 FUJITSU LIMITED
End of procedure
Figure
5.8, step 2),
P3AM-5392-07ENZ0