6 CONTROL PANEL
6.2.2
Internal control panel
1.
Knob for setting the gas flow rate
6.3
Setting the gas flow
The gas flow is adjusted using the knob on the internal control panel. The
present gas flow rate is presented on the gas flow meter above the knob.
NOTE!
The reading on the flow meter scale will only be correct if the wire
feeder is in upright position!
6.4
Rotating the external control panel
For use of the wire feeder in horizontal position there is a possibility to rotate the external
control panel 90°.
1.
Remove the two screws for the control panel and remove the panel.
2.
Rotate the control panel 90° counter-clockwise.
3.
Attach the control panel making sure the small tabs are in the correct position.
4.
Fasten the screws.
0446 253 101
- 32 -
© ESAB AB 2020