Changing The Wire Guides; Inlet Wire Guide; Middle Wire Guide - ESAB Aristo Robust Feed U6 Instruction Manual

5 OPERATION
6. Lock the rollers by rotating the roller quick locks (A).
7. Close and lock the left door of the wire feeder.
5.11

Changing the wire guides

When changing to a different type of wire, the wire guides may have to be changed to match
the new type of wire. For information about the correct wire guides depending on wire
diameter and type, see the WEAR PARTS appendix. (For a tip about easy access to
necessary wear parts, see the "Wear parts storage compartment" section in this manual.)
5.11.1

Inlet wire guide

1. Unlock the inlet wire guide quick
lock (A) by folding it out.
2. Remove the inlet wire guide (B).
3. Install the correct inlet wire guide
(according to the WEAR PARTS
appendix).
4. Lock the new inlet wire guide using
the wire guide quick lock (A).
5.11.2

Middle wire guide

1. Apply a little pressure on the middle
wire guide clip and pull out the
middle wire guide (A).
2. Push in the correct type of wire
guide (according to the WEAR
PARTS appendix). The clip
automatically locks the wire guide
when in the correct position.
0446 253 101 - 22 - © ESAB AB 2020