Introduction; Equipment - ESAB Aristo Robust Feed U6 Instruction Manual

2 INTRODUCTION

2 INTRODUCTION
The Robust Feed equipped with a U6 or Pulse control panel, is intended for MIG/MAG
welding together with 400 A, 500 A and 600 A CAN based welding power sources.
The wire feed unit comes in different variants (see the "ORDERING NUMBERS" appendix).
NOTE!
Wire feed unit variants equipped with ESAB Logic Pump (ELP), is intended to be
used together with welding power sources equipped with ELP. For further
information about ELP, see the "Cooling liquid connection" section.
The wire feed units are sealed and contain four-wheel drive wire feed mechanisms as well as
control electronics.
They can be used together with wire from ESAB's Marathon Pac™ or from wire bobbin
(standard Ø 200 mm and Ø 300 mm).
The wire feed unit can be placed on a trolley, suspended above the workplace or on the floor
(standing up or laying down and with or without a wheel set).
ESAB accessories for the product can be found in the "ACCESSORIES" chapter of
this manual.
2.1

Equipment

The wire feed unit is supplied with:
• An instruction manual in the local language for the wire feed unit
• An instruction manual in English language for the control panel
• Drive rolls: 0.9/1.0 mm (0.040 in.) / 1.2 mm (0.045 in.)
• Guide tubes: 0.6–1.6 mm (0.023–1/16 in.)
Instruction manuals in other languages can be downloaded from the Internet:
manuals.esab.com
0446 253 101 - 9 - © ESAB AB 2020