ESAB Aristo Robust Feed U6 Instruction Manual page 19

5 OPERATION
The graphic above shows retrofit of the interconnection strain relief kit (ordering no. 0446 050
880) where the welding current and control cables and, if applicable, also the cooling liquid
and shielding gas hoses are routed through the strain relief device.
There is also the possibility to use a pre-assembled interconnection cable kit, including strain
relief (see the "ACCESSORIES" appendix).
NOTE!
• The interconnection strain relief should be clamped to clean cables.
• Locate the welding current cable in the larger of the two holes in the strain
relief clamp!
• Ensure that the cable ties around the insulating sleeve are tightened
properly!
0446 253 101 - 19 - © ESAB AB 2020