System Reliability Guidelines; Handling Static-Sensitive Devices; Returning A Device Or Component - IBM IntelliStation M Pro 6218 Problem Determination And Service Manual

System reliability guidelines

To help ensure proper system cooling and system reliability, make sure that the
following requirements are met::
v Each of the drive bays has a drive or a filler panel and electromagnetic
v There is adequate space around the computer to allow the computer cooling
v You have followed the cabling instructions that come with optional adapters.
v You have replaced a failed fan as soon as possible.
v You do not operate the computer without the air baffle installed. Operating the

Handling static-sensitive devices

Attention:
devices. To avoid damage, keep static-sensitive devices in their static-protective
packages until you are ready to install them.
To reduce the possibility of electrostatic discharge, observe the following
precautions:
v Limit your movement. Movement can cause static electricity to build up around
v The use of a grounding system is recommended. For example, wear an
v Handle the device carefully, holding it by its edges or its frame.
v Do not touch solder joints, pins, or exposed circuitry.
v Do not leave the device where others can handle and damage it.
v While the device is still in its static-protective package, touch it to an unpainted
v Remove the device from its package and install it directly into the computer
v Take additional care when handling devices during cold weather. Heating reduces

Returning a device or component

If you are instructed to return a device or component, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to you.
74
IBM IntelliStation M Pro Type 6218 and 9236: Problem Determination and Service Guide
compatibility (EMC) shield installed in it.
system to work properly. Leave approximately 50 mm (2 in.) of open space
around the front and rear of the computer. Do not place objects in front of the
fans. For proper cooling and airflow, replace the computer cover before turning
on the computer. Operating the computer for extended periods of time (more
than 30 minutes) with the computer cover removed might damage computer
components.
computer without the air baffle might cause the microprocessor to overheat.
Static electricity can damage the computer and other electronic
you.
electrostatic-discharge wrist strap, if one is available.
metal part of the computer for at least 2 seconds. This drains static electricity
from the package and from your body.
without setting down the device. If it is necessary to set down the device, put it
back into its static-protective package. Do not place the device on the computer
cover or on a metal surface.
indoor humidity and increases static electricity.