Configuring The Broadcom Netxtreme Gigabit Ethernet Controller - IBM IntelliStation M Pro 6218 Problem Determination And Service Manual

7. Exit from the ServeRAID Manager program and remove the CD from the
8. Restart the computer.
Using the custom configuration: To use the custom configuration, complete the
following steps:
10. Click Apply. Click Yes when asked if you want to apply the new configuration.
11. Exit from the ServeRAID Manager program, and remove the CD from the
12. Restart the computer.
Viewing the configuration
You can use ServeRAID Manager to view information about RAID controllers and
the RAID subsystem, (such as arrays, logical drives, hot-spare drives, and physical
drives). When you click an object in the ServeRAID Manager tree, information about
that object appears in the right pane. To display a list of available actions for an
object, click the object and click Actions. To display available actions for an item,
click the item in the ServeRAID Manager tree and click Actions.

Configuring the Broadcom NetXtreme Gigabit Ethernet controller

The Ethernet controller is integrated on the system board. It provides an interface
for connecting to a 10-Mbps, 100-Mbps, or 1-Gbps network and provides full duplex
(FDX) capability, which enables simultaneous transmission and reception of data on
the network. If the Ethernet port in the computer supports auto-negotiation, the
controller detects the data-transfer rate (10BASE-T, 100BASE-TX, or 1000BASE-T)
and duplex mode (full-duplex or half-duplex) of the network and automatically
operates at that rate and mode.
You do not have to set any jumpers or configure the controller. However, you must
install a device driver to enable the operating system to address the controller. For
device drivers and information about configuring the Gigabit Ethernet controller, see
http://www.ibm.com/support/.
CD-ROM drive.
1. In the ServeRAID Manager tree, click the controller that you want to configure.
2. From the toolbar, click Create.
3. Click Custom configuration.
4. Click Next. The "Create arrays" window opens.
5. Click the applicable tab in the right pane, and from the list of ready drives,
select the two drives you want to move to the array.
6. Click the icon to add the drives to the array.
7. If you want to configure a hot-spare, complete the following steps:
a. Click the Spares tab.
b. Select the physical drive you want to designate as the hot-spare drive, and
click the icon to add the drive.
8. Click Next. The "Configuration summary" window opens.
9. Review the information that is displayed in the "Configuration summary"
window. To change the configuration, click Back.
The configuration is saved in the controller and in the physical drives.
CD-ROM drive.
Chapter 5. Configuration information and instructions
133