Removing and installing internal drives
This section describes the removal and installation of internal drives (see Figure 31
for the location of the drive bays). See the User's Guide for more information about
the types of drives that the computer supports.
Bay 1
Bay 2
Bay 3
Bay 4
Figure 31. Internal drive bay locations
Removing a drive in bay 1 or 2
To remove a drive in bay 1 or 2, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the computer and all attached devices; then, disconnect all external
3. Remove the side cover (see "Removing the side cover" on page 75).
4. Remove the front bezel (see "Removing the bezel" on page 77).
5. Remove the hard disk drive bracket, if one is installed (see "Removing the hard
6. Disconnect the cables from the drive that you are removing.
7. Release the drive from the bay by pressing the blue release button on the side
98
IBM IntelliStation M Pro Type 6218 and 9236: Problem Determination and Service Guide
on page 73.
cables and power cords.
disk drive bracket" on page 95).
of the drive; then, pull the drive out of the computer (seeFigure 32 on page 99).
Bay 5