IBM IntelliStation M Pro 6218 Problem Determination And Service Manual page 120

8. Install the side cover (see "Installing the side cover" on page 76).
9. Reconnect the external cables and power cords; then, turn on the attached
Removing a drive in bay 5
To remove a drive in bay 5, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the computer and all attached devices; then, disconnect all external
3. Remove the side cover (see "Removing the side cover" on page 75)
4. Disconnect the signal and power cables from the hard disk drive.
5. Remove the thumbscrew at the rear of the drive.
6. Lift the rear of the drive out of the hard disk drive bracket; then, slide the
Figure 36. Removing a drive from bay 5
7. If you are replacing the hard disk drive with a new drive, remove the two
104
IBM IntelliStation M Pro Type 6218 and 9236: Problem Determination and Service Guide
devices and the computer.
on page 73.
cables and power cords.
shoulder screws at the front of the drive out of the guide slots in the hard disk
drive bracket (see Figure 36).
Guide slots
shoulder screws, one on each side, at the front of the drive and store them for
reuse (see Figure 37 on page 105).
Thumbscrew