Removing And Replacing Frus; Removing The Front I/O Panel - IBM IntelliStation M Pro 6218 Problem Determination And Service Manual

Removing and replacing FRUs

FRUs must be installed only by trained service technicians.
The illustrations in this document might differ slightly from your hardware.

Removing the front I/O panel

To remove the front I/O panel, complete the following steps:
Figure 43. Removing the front I/O panel
110
IBM IntelliStation M Pro Type 6218 and 9236: Problem Determination and Service Guide
1. Read the safety information that begins on page vii and "Installation guidelines"
on page 73.
2. Turn off the computer and all attached devices; then, disconnect all external
cables and power cords.
3. Remove the side cover (see "Removing the side cover" on page 75).
4. Remove the hard disk drive bracket, if one is installed (see "Removing the
hard disk drive bracket" on page 95).
5. Remove the front bezel (see "Removing the bezel" on page 77).
Note: It might be helpful to lay the computer on its left side for the remainder
of this procedure.
6. Remove the drive cage from the computer (see Figure 23 on page 89):
a. Loosen the thumbscrew at the rear of the drive cage.
b. Slide the drive cage to the rear to disengage it from the upper clips and lift
the cage out of the computer.
Note: You might have to disconnect the power cables from the drives
before you lift the cage all the way out of the computer.
7. Disconnect the internal IEEE 1394 (FireWire) cable and front-panel cable from
the system board (see "System-board internal connectors" on page 7 for
connector locations).
8. Disconnect the power switch/LED assembly cable from the back of the I/O
card.
9. Remove the I/O panel screw on the front of the computer (see Figure 43).