Features And Specifications - IBM IntelliStation M Pro 6218 Problem Determination And Service Manual

Features and specifications

The following table provides a summary of the features and specifications of the
computer. Depending on the model, some features might not be available, or some
specifications might not apply.
Use the Configuration/Setup Utility program to determine the type and speed of the
microprocessor.
Table 1. Features and specifications
Microprocessor:
® ®
v Intel Pentium processor
v 2 MB Level-2 cache
v 800 MHz front-side bus (FSB)
Memory:
v Minimum: 1 GB
v Maximum: 8 GB
v Type: PC2-4200, dual-data-rate 2
(DDR2) un-buffered error correcting
code (ECC)
v Connectors: four dual inline memory
module (DIMM) connectors
Internal drives:
v Diskette: 1.44 MB (two mode)
(optional)
v Hard disk drive: SATA, SCSI, or SAS
v One of the following drives:
– DVD/CD-RW combo: IDE
– CD-RW: IDE
Expansion bays:
v One slim-high 3.5-inch external drive
bay, (optional)
v Two half-high 5.25-inch bays (optical
drive installed in one bay)
v Two slim-high 3.5-inch internal drive
bays (one hard disk drive installed)
PCI expansion slots:
v One PCI Express x1 slot
v One PCI Express x8 slot (x4
electrical)
v One PCI Express x16 slot (support
x16 video cards only)
v One 33 MHz/32-bit PCI slot
Power supply:
One 400-watt (115-230 V ac)
Cooling:
v One speed-controlled fan and one
power supply fan
Integrated functions:
v Broadcom 5721 10/100/1000 Ethernet
controller with RJ-45 Ethernet connector
v Single-channel SCSI provided by a
mini-PCI card
v Two serial connectors
v One parallel connector
v Three-port serial ATA controller
v Two IEEE 1394 (FireWire) connectors
(four-pin on front, six-pin on rear)
v Eight Universal Serial Bus (USB)
connectors (two on front and six on
rear)
v Keyboard connector
v Mouse connector
v Audio connectors
– Line out (front and rear)
– Mic (front)
– Line in (rear)
v Single-channel IDE controller
Video adapter: (depending on the model)
v NVIDIA Quadro NVS 280 (DMS-59),
PCI Express x16, with 64 MB DDR
synchronous dynamic random access
memory (SDRAM) video memory and
dual analog connectors (or dual digital
monitor capability with the purchase of
an additional pigtail cable)
v ATI FireGL V3100 (DVI-I), PCI Express
x16, with 128 MB DDR SDRAM video
memory with dual DVI-I and VGA
connectors
v NVIDIA FX 1400 (DVI-I), PCI Express
x16, with 128 MB DDR SDRAM video
memory with dual DVI-I connectors
v ATI FireGL V7100 (DVI-I), PCI Express
x16, with 256 MB GDDR3 SDRAM
video memory with dual DVI-I
connectors
v 3DLabs Wildcat Realizm 800 (DVI-I).
PCI Express x16, with 512 MB GDDR3
(512-bit Unified) and 128 MB GDDR3
(128-bit direct burst) SDRAM video
memory with dual DVI-I connectors
Electrical input:
v Sine-wave input (50 or 60 Hz) required
v Input voltage and frequency ranges
automatically selected
v Input voltage low range:
– Minimum: 90 V ac
– Maximum: 137 V ac
v Input voltage high range:
– Minimum: 180 V ac
– Maximum: 265 V ac
v Input kilovolt-amperes (kVA) approximately:
– Minimum: 0.12 kVA
– Maximum: 0.58 kVA
Heat output:
Approximate heat output in British thermal
units (Btu) per hour:
v Minimum configuration: 433 Btu (127 watts)
per hour
v Maximum configuration: 1948 Btu (571
watts) per hour
Environment:
v Air temperature:
– Computer on: 10° to 35°C (50° to 95°F)
Altitude: 0 to 2134 m (7000 ft)
– Computer off: -40° to +60°C (-40° to
140°F)
Maximum altitude: 2133 m (7000 ft)
v Humidity (operating and storage): 8% to
80%
Acoustical noise emissions:
v Sound power, idle: 4.3 bel
v Sound power, operating: 4.9 bel
Size:
v Height: 435 mm (17.12 in.)
v Depth: 445 mm (17.5 in.)
v Width: 178 mm (7 in.)
v Weight: 10.5 kg (23 lb) to 13.5 kg (30 lb)
depending upon configuration
Chapter 1. Introduction
3