IBM IntelliStation M Pro 6218 Problem Determination And Service Manual page 76

v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See Chapter 3, "Parts listing," on page 65 to determine which components are customer replaceable units
(CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a
trained service technician.
Error code
4xxx thru 5xxx
7xxx thru 8xxx
9003
9xxx thru BZxx
EFFE
60
IBM IntelliStation M Pro Type 6218 and 9236: Problem Determination and Service Guide
Description
A Code DRAM error occurred.
A host/local PCI bus interface error
occurred.
A ServeRAID controller error occurred.
A SCSI bus error was caused by the
cables, termination, defective drives, or
other components. Z refers to the
specific channel or channels that cause
the error.
The firmware code is corrupt or the
download jumpers are in place.
Action
1. Install the download jumpers, flash the latest
level of BIOS code and firmware for
controller. Then, remove the jumpers.
2. Reseat the ServeRAID controller.
3. Replace the ServeRAID controller.
1. Flash the latest level of BIOS code and
firmware for the controller.
2. If ServeRAID-8i controller, integrated RAID
controller on the computer.
1. Flash the latest level of BIOS code and
firmware for controller.
2. Make sure that the controller is supported for
this computer.
3. Integrated RAID controller on the computer.
1. Follow the instructions in "Interrupt status
port register (ISPR) error procedures" on
page 57
2. Make sure that the SCSI cable is connected
correctly.
3. Reseat the following components:
a. Hard disk drive
b. ServeRAID controller
4. Replace the following components one at a
time, in the order shown, restarting the
computer each time:
a. Hard disk drive
b. ServeRAID controller
1. Flash the latest level BIOS code and
firmware for the controller. Then, remove the
jumpers.
2. Reseat the ServeRAID controller.
3. Replace the ServeRAID controller.