Table of Contents
Advertisement
Operating Tasks
Port Configuration
Configuration Examples (Broadcast Mode)
Setting up two or four outputs of the same signal (broadcast mode). In this
example the output ports are RFIO 5, 6, 7, and 8. It would be also be possible
to use ports RFIO 5 and 6, or ports RFIO 7 and 8.
Figure 5-19
Example: broadcast mode (ports 5 - 8)
Set up the RF Output using this command:
:FEED:RF:PORT:OUTP:BROadcast P5678
76
Broadcast mode is set up only by means of SCPI commands, not by making
menu selections.
Getting Started Guide
Advertisement
Table of Contents
