Table of Contents
Advertisement
Exterior Features
Front Panel Features
Controller interface
Figure 3-2
Controller interface
Connector/Indicator
(1)
Monitor Port
(2)
Drive/Power/User
(3)
Trig
(4)
LAN1 & LAN2
(5)
USB 3.0 (SS)
(6)
USB 2.0
Getting Started Guide
Description
This connector supports a connection to a monitor with a DisplayPort input.
—DRIVE: When the Solid State Drive is active, the LED will flash.
—POWER: If the LED is on, the power supply to the controller is good and the
system should boot.
—USER: Not used.
This BNC trigger connector is not used by the E6680A.
Two TCP/IP Interface connectors that are used for remote test set operation. Choose the LAN 1
port to have an IP address assigned to the test set dynamically, using DHCP. If your local
network does not support DHCP, choose the LAN 2 port to use a private static IP address. (
"Port Configuration" on page 67.
Two USB 3.0 interface ports are provided.
Four USB 2.0 interface ports are provided.
)
See
29
Advertisement
Table of Contents
