Launch Icons; Launch Modular Trx - Keysight Technologies S8780A Getting Started Manual

User Interface

Launch Icons

Launch Icons
Two desktop icons provide access to utilities which support the E6680A's
measurement applications.
The Launch Modular TRX icon is used to activate the TRXs individually. The
Configure Applications icon is used to determine which measurement
applications run by default when a TRX is activated.
Figure 4-1 Desktop icons

Launch Modular TRX

This tool shows which of the four possible TRXs are installed in the PXIe rack,
and identifies them by SCPI address. At a minimum, TRX1 must be installed,
and cannot be disabled using this tool. However, the other TRXs, if installed,
can be enabled or disabled using the checkboxes in the left column. When the
desired TRXs are selected in the checkboxes, click Run Selected to activate
them. (The UpdateFPGA button is used when installing a new TRX into an
E6680A which was purchased without it, to ensure software compatibility.)
Figure 4-2 Modular TRX tool
The Module Licenses button is used to check the status of licensed features
for each TRX. The Update FPGA button is used when installing a new TRX into
an E6680A which was purchased without it, to ensure software compatibility.
36 Getting Started Guide