Analog Output Module Command - Advantech ADAM 4000 Series User Manual

4021

4.5 Analog Output Module Command

Command Syntax
%AANNTTCCFF
#AA(data)
$AA4
$AA3 (number of
counts)
$AA0
$AA1
$AA2
$AA6
$AA8
$AA5
$AAF
$AAM
Command Name
Configuration Sets the address, output range, baud
rate, data format, slew rate and/or
checksum status
Analog Data Out Directs output data to a specified
module
Start-Up Output Stores a default output value in a
Current or specified module. The output value
Voltage will take effect upon startup
Configuration
Trim Calibration Trims specified module a number of
units up/down
4 mA Calibration Tells the module to store parameters
for 4mA Calibration
20 mA Calibration Tells the module to store parameters
for 20 mA Calibration
Configuration Reads the configuration of specified
Status module
Last Value Returns either last value sent to
Readback specified module by #AA command, or
start-up output current/voltage
Current Readback Returns measured value of the
current/voltage flowing through
current loop
Reset Status Checks if module has been reset since
the last $AA5 command
Read Firmware Returns the firmware version code
Version from the specified analog output
module
Read Model Return the module name from
Name specified analog output module
Description
Chapter 4 Command Set
4
Chapter
I/O
Module
4021
4021
4021
4021
4021
4021
4021
4021
4021
4021
4021
4021
4-127