Service; Preparation For Use - Eurotrac W11E Operation Manual

• Use a non-metallic brush to remove corrosion from the lithium battery cable terminals.
• Use 1∕4 pound of soap to add a gallon of water to clean the painted surface of the vehicle.
• Clean with clean water and dry with linen or air.
First maintenance program
• First time maintenance must be performed between 10 and 125 hours of operation.
• For motor maintenance, see the motor operating manual (this unit comes with the motor operating manual).
• Check for oil leaks and correct if necessary.
• Check hoses and connections and check the wires.
• Check the rim nut torque after 10 hours of operation, also for more than 50 hours and check the rim nut torque
after each wheel change.
3.3

Service

3.3.1

Preparation for use

Lithium battery
Brake system
Travel motor
Rear axle and reducer
Tire Air Refill
Hydraulic oil
WARNING
Due to pressure in the hydraulic tank, loosen the filler cap and slowly release the pressure before opening.
Grease points
Add in each grease point
1. All joint bearings
2. All hinges
3. All bushings
Page 30/72
W11E | Operation manual
Connect the lithium battery cable. If it is disconnected, connect the positive pole first.
Make sure the lithium battery is fully charged.
Check if the brake fluid leaks.
Slowly start the vehicle, release the throttle, and step on the jog pedal to check the
brake effect.
Check that the travel motor is operating normally.
Check the line connection.
Check the axle oil level and refuel if necessary.
Check the tire air pressure and inflate if necessary.
After removing the wheel, it is recommended to tighten the nut: 2 hours, 50 hours,
every 200 hours.
Recommended wheel nut tightening: 372N.m
Recommended wheel pressure W11E: 3.0Bar
Check the hydraulic tank level and the lowest level is indicated on the filter at the
filler.
October 2019