•
Slow down when approaching corners
•
Observe pedestrians carefully and do not follow the vehicle in front too closely.
•
Do not brake sharply and only select neutral once the loader has effectively stopped.
•
Maintain a safe distance from the edge of loading wharf.
•
When turning, pay close attention to the trajectory of the buckets.
•
Make sure that bridges and ramps are able to withstand the weight of the loader and the load being towed.
•
Before climbing or descending from vehicles (trucks, trails etc), ensure that the adequate precautions are been
taken to avoid all movements including the dumping.
•
Stop, look at and listen when arriving to a rail way then to cross it in diagonal, slowly and only to the authorized
points.
•
Always park at more than 2,5m of the rails.
•
Hold the wheel steering in hand during the operation.
•
When loading a larger load, more space for the overtaking of parked vehicles, objects or pedestrians should be
predicted.
•
Never overtake another vehicle on crossroad or on bifurcations or when something affects the visibility for you.
•
Never drive in elevators, truck or other until you have received the order and you are sure that they can stand
the combined weight of loader and the load.
•
Doesn't brake roughly.
•
Pay attention to the driving speed and be careful to the pedestrians approaching and other vehicles and to the
passage heights.
•
Slow down on wet, irregular grounds and in the turning.
•
Remove all objects in your way.
•
On the crossroad, in the passages and the corridors, slow down and horn and drive on the right side of the road.
•
Be careful to the pedestrians which can appear suddenly in the way.
•
If your trip involves crossing road bridge, ensure they are secure and are strong enough to withstand the
combined weight of the loader and load.
•
When approaching the destination, reduce the speed to ensure a smoothly slow stop in the far enough
distance. A sudden halt could cause the load displacement.
•
In the event of an emergency, first place the load on the ground before you proceed with further action.
•
Report any mechanical or electrical irregularities immediately.
•
Always be alert; Watch out for pedestrians and never drive too close to the vehicles in front.
•
Travel at a speed consistent with load and road conditions.
•
Never operate the loader with any part of your body outside of the operator's compartment.
•
DO NOT leave the driver's cab with the loader running.
•
ALWAYS properly shut down the loader before leaving the loader.
•
ALWAYS park the loader on solid, level ground.
On severe slopes
•
ALWAYS park the loader perpendicular to the steepest slope to prevent accidental movement.
•
Use proper flags, warning marks or barriers when parking in areas of traffic.
•
Do not park your vehicle in the access points where obstruct the fire brigade.
•
During parking, use the parking brake and put the key on the STOP position.
•
If the tractor must leave with nobody watching it, remove the ignition key.
•
Never park your vehicle on a slope.
•
If it is necessary to park tractor on a slope (break down etc), use the wedge under the wheels of loader.
•
Do not drive while the rear cover is open.
•
Don't make dangerous modifications to lithium batteries.
Page 21/72
W11E | Operation manual
October 2019
Need help?
Do you have a question about the W11E and is the answer not in the manual?