Eurotrac W11E Operation Manual page 17

• When driving with a load, the bucket should be raised to the transformational position (about 20cm from the
ground).
• When driving on the ramp, goods shall be towards the uphill direction. U-turns and parallel driving on ramps
must be avoided.
• Only operate the machine when having clear and unobstructed view.
• When uninstalling, raise the bucket to an appropriate height, as carefully as you can accurately to drive the
wheel loader to the truck or the place for goods storage; Carefully control the master control lever, uninstall,
reset; Confirming that the bucket and the truck (shelf) is completely separated, the loader moves slowly back
to leave the shelf.
• When reaching the parking spot, shift it into neutral position, raise the parking brake, and turn off the ignition
switch.
NOTE
Safe and efficient loading, depends entirely on the operator. If you are an experienced driver, the following rules
will refresh your memory. If you are a student, they will help you to become a professional driver.
WARNING
Only qualified and licensed drivers allowed to drive.
WARNING
Before starting loading, please make sure the cylinder of the quick removal device is in the locking position, set the
locking tools, and cut the two-way ball valve off.
WARNING
When driving on the ramp (forward or backward), goods shall be towards the uphill direction. Driving or u-turn
ramping on the horizontal should be avoided.
WARNING
When the goods are in a lifting state, do not leave the loader.
WARNING
When the goods are in a lifting state, the loader can not turn around and can not run at high speed.
Page 17/72
W11E | Operation manual October 2019