Troubleshooting And Fault Codes; Fault Levels; Fault List - Eurotrac W11E Operation Manual

4.2

Troubleshooting and fault codes

4.2.1

Fault levels

PRIORITY
1 (HIGHEST)
2
3
4 (LOWEST)
4.2.1

Fault list

Code Fault
1 Over Voltage
2 Under Voltage
3 User
Over Voltage
4 User
Under Voltage
5 Inverter 1
Over Current
6 Inverter 2
Over Current
7 -
Page 44/72
W11E | Operation manual
Level Family Possible Causes
Blocking All • Battery resistance too high while
regenerating.
• Battery disconnected while
regenerating.
Blocking All • Battery seriously damaged or
exhausted.
• Battery resistance too high.
• Battery disconnected while driving.
• Blown key-switch fuse.
• External load drains power from
battery.
Blocking TAU • Battery resistance too high while
System regenerating.
• Battery disconnected while
regenerating.
• Too low voltage level defined by the
user
Blocking TAU • Battery serious damaged or
System exhausted.
• Battery resistance too high.
• Battery disconnected while driving.
• Blown key-switch fuse.
• External load drains power from
battery.
• Too high voltage level defined by the
user.
Blocking All • External or internal short-circuit
between U1, V1 or W1 AC motor's
phases.
• Incorrect motor 1 parameter/s.
• Inverter 1 power module damaged.
Blocking All • External or internal short-circuit
between U2, V2 or W2 AC motor's
phases.
• Incorrect motor2 parameter/s.
• Inverter 2 power module damaged.
- All -
LEVEL
Blocking
Stopping
Limiting
Warning
Set Condition
Key-switch voltage or
capacitors voltage is
above the maximum
level allowed for the
controller.
Key-switch voltage is
below the minimum
level allowed for the
controller.
Key-switch voltage is
above the maximum
level defined by the
user.
Key-switch voltage is
below the minimum
level defined by the
user.
Inverter 1 phase current
exceeded its current
limit.
Inverter 2 phase current
exceeded its current
limit.
-
ACTIONS
Main contactor opened
Motors disabled
Outputs disabled
Main contactor closed
Motors stopped
Outputs enabled
Main contactor closed
Motors limited
Outputs enabled
Main contactor closed
Motors enabled
Outputs enabled
Clear Condition
Bring key-switch voltage
below over-voltage limit
and then cycle key
switch.
Bring key-switch voltage
above under-voltage
limit and then cycle key
switch.
Bring key-switch voltage
below user over voltage
limit and then cycle key
switch.
Bring key-switch voltage
above user under voltage
limit and then cycle key
switch.
Cycle key switch.
Cycle key switch.
-
October 2019