Mechanical Responsibility - Eurotrac W11E Operation Manual

1.3.3

Mechanical responsibility

You must read this chapter and thoroughly understand it before performing any maintenance on the device.
WARNING
Failure to observe the following safety precautions can result in serious injury or death, as well as equipment
damage.
1. Always follow local safety regulations.
2. The operator must be familiar with the operation of the machine before using it.
3. Always keep your hands and feet away from rotating parts and tires, and wear safety uniforms.
4. Always wear the right shoes when handling or servicing equipment. Avoid wearing loose clothing, which may
get stuck in moving parts.
5. Always ensure the cleanliness of the controller cooling fan.
6. Do not start the machine in an explosive environment.
7. Do not check gear oil when the motor is running.
8. Always disconnect the main power switch of the lithium battery when working on the travel motor.
9. If the lithium battery is overheated or abnormally discharged, do not attempt to perform repairs in private.
Please contact a professional for repair.
10. Do not touch the oil pump motor and the travel motor when it is hot, otherwise it will cause severe burns.
11. Do not smoke near a lithium battery. Always keep the lithium battery away from sparks, flames and smoking.
12. Always remove the metal bracelet, watch strap, etc. before installing, removing or maintaining the lithium
battery.
13. Do not allow short circuit lithium battery terminals.
14. When connecting a lithium battery, always connect the positive terminal first to prevent sparks.
15. Check all lights.
16. Check the reverse warning alarm.
17. Make sure the machine is in neutral when starting. Put the seat, handlebars and mirrors in the correct position
before use.
18. Check tire and wheel conditions for proper inflation pressure. Excessive inflation can cause tires to explode.
19. Tighten the rim nut to a torque of 130 ft-lbs. Check the torque after 5 hours of operation.
20. Use appropriate lifting equipment when removing or replacing heavy parts.
21. When working under the loader, make sure that it is properly supported on the safety crane. Not completely
dependent on hydraulic jack support loader.
22. If the loader is raised under a hydraulic or air lift, ensure that the loader has a secure support or fixed position
before working under the loader.
23. When checking or repairing the drive system failure, jack up the drive wheel.
24. Do not smoke when injecting oil.
25. Do not use the lithium battery of this car to start other vehicles.
Page 9/72
W11E | Operation manual October 2019