Oil & Lubricant - Eurotrac W11E Operation Manual

Hydraulic oil replacement
WARNING
The front working unit should be lowered completely before draining the hydraulic fluid.
1. Drive the loader to the trench.
2. Lower the front working device completely.
3. Place a container on the bottom of the loader.
4. Open the rear cover.
5. Unscrew the hydraulic oil filler port.
6. Unscrew the suction filter.
7. Remove the drain plug of the hydraulic tank.
8. Fully drain the hydraulic oil.
9. Wipe the area near the drain plug.
10. Reinstall the drain plug.
11. Make sure the replaced oil filter is filled with oil to avoid damages.
12. Tighten the filler cap.
13. Fill the oil filter port with the hydraulic oil until it is full.
14. Tighten the oil filter cover back.
15. Start the engine, run for a while in the idle state, repeatedly turn the steering wheel to the left and right to the
maximum corner several times, let the car slowly drive for dozens of meters and lift down several times, and
check the oil level again.
CAUTION
Discarded oil should be disposed of in accordance with relevant regulations. Avoid skin contact with oil. Also don't
let the oil flow into the sewer or flow to the ground.
3.3.3 Oil & Lubricant
Hydraulic system
Model Specification
W11E
Drive axle
Model Specification
W11E
CAUTION
The oil mentioned above is used under normal weather conditions. For a coldest or hottest country, please contact
EUROTRAC or dealer.
Page 33/72
W11E | Operation manual
Caltex HDZ-46
66L
Gear Oil L-CKC 220
2L
October 2019